ASTM-A610 › Standard Test Methods for Sampling and Testing Ferroalloys for Determination of Size
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 These test methods include procedures for the sampling and testing of the various ferroalloys for sizing, either before or after shipment from the plants of the manufacturers.
1.2 They are designed to give results representative of each lot that will be comparable with the manufacturer's certified analysis for the same lot.
1.3 The purchaser may use any sampling procedure he desires, but the results obtained on such samples shall not be a basis for complaint or rejection, unless the procedure followed is of an accuracy equivalent to that prescribed in these test methods.
1.4 The values stated in inch-pound units are to be regarded as the standard. The SI equivalents of inch-pound units may be approximate.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
Ferroalloys; Iron castings (testing); Sampling-ferrous alloys; Size; Steel/stainless steel-alloying additives; sampling/testing ferroalloys for size, methods; ICS Number Code 77.100 (Ferroalloys)
To find similar documents by ASTM Volume:
01.02 (Ferrous Castings; Ferroalloys)
To find similar documents by classification:
77.100 (Ferroalloys Including classification, designation, sampling, chemical analysis, etc.)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Customers who bought this document also bought:
BS-EN-809Pumps and pump units for liquids. Common safety requirements
UL-51
Standard for Power-Operated Pumps for Anhydrous Ammonia and LP-Gas
BS-EN-ISO-13857
Safety of machinery. Safety distances to prevent hazard zones being reached by upper and lower limbs
Document Number
ASTM-A0610-79R19
Revision Level
1979 R19 EDITION
Status
Current
Modification Type
Reapproval
Publication Date
Nov. 1, 2019
Document Type
Test Method
Page Count
2 pages
Committee Number
A01.18