Document Center is acquired by Nimonik

Scope

1.1 This test method covers measurement of the lamination factor (Note 1) of a specimen composed of strips cut from magnetic material.

Note 1—Lamination factor is also termed space factor or stacking factor.

1.2 This test method shall be used in conjunction with Practice A 34/A 34M.

1.3 The values and equations stated in customary (cgs-emu and inch-pound) or SI units are to be regarded separately as standard. Within this test method, SI units are shown in brackets. The values stated in each system may not be exact equivalents; therefore each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with this test method.

1.4 This standard does not purport to address the safety concerns associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Significance and Use

Lamination factor, S, indicates the deficiency of effective steel volume which is due to the presence of oxides, roughness, insulating coatings, and other conditions affecting the steel surface.

Keywords

lamination factor; space factor; stacking factor; Electrical steel; Laminations; Magnetic properties; Steel sheet (electrical); ICS Number Code 29.030 (Magnetic materials)

To find similar documents by ASTM Volume:

03.04 (Magnetic Properties)

To find similar documents by classification:

29.030 (Magnetic materials Steels with special magnetic properties, see 77.140.40)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.