ASTM-A793 › Standard Specification for Rolled Floor Plate, Stainless Steel (Withdrawn 2023)
The following bibliographic material is provided to assist you with your purchasing decision:
This specification covers the standard for stainless steel floor plates for use in galley spaces, washrooms, engine rooms, and machinery spaces, and for ladder treads, gun platforms, and deck treads. Several steel grades like Type 304, 304L, 316, 316L used as floor plate material shall conform to the chemical composition requirements in carbon, manganese, phosphorus, sulfur, silicon, nitrogen, nickel, chromium, and molybdenum as determined by heat analysis. Annealing shall be the last heat treatment to which the material is subjected. The stainless steel floor plate shall be in patterns with uniform pitch from center to center, angular figures shall be arranged such that they are in angular position from a vertical or horizontal line and shall have a raised figure. Mechanical properties shall be tested by two longitudinal cold bend tests and the raised figure shall not fracture nor develop cracks or flaws on the materials. Magnetic permeability test shall also be performed on the plates and shall meet the specified magnetic permeability indicator. Floor plates of stainless steel shall be uniform in quality and condition, and free of injurious defects that may detrimentally affect the suitability for the service for which they are intended.
Scope
1.1 This specification covers stainless steel floor plates 1/2 in. and under for use in galley spaces, washrooms, engine rooms, and machinery spaces, and for ladder treads, gun platforms, and deck treads. For these uses, Patterns A, B, and C are considered interchangeable (see Fig. 1, Fig. 2, and Fig. 3).
1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
To find similar documents by ASTM Volume:
01.03 (Steel--Plate, Sheet, Strip, Wire; Stainless Steel Bar)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Customers who bought this document also bought:
MIL-STD-810Environmental Engineering Considerations and Laboratory Tests
MIL-STD-2105
Hazard Assessment Tests for Non-Nuclear Munitions
MIL-STD-907
Engineering and Design Criteria for Shelters, Expandable and Non-Expandable (Superseded by ASTM-E1925)
Document Number
ASTM-A793-96(2014)
Revision Level
1996 R14 EDITION
Status
Cancelled
Modification Type
Withdrawn
Publication Date
April 1, 2014
Document Type
Specification
Page Count
4 pages
Committee Number
A01.17