ASTM-A921 › Historical Revision Information
Standard Specification for Steel Bars, Microalloy, Hot-Wrought, Special Quality, for Subsequent Hot Forging
The following bibliographic material is provided to assist you with your purchasing decision:
This specification covers hot-wrought, special quality microalloyed carbon steel bars intended for use as hot forging stock. The bars shall be hot-wrought, as-wrought, unless thermal treatment is necessary to ensure cold shearability. The steel specimens shall be killed and shall conform to the fine grain size requirement. Heat analysis and product analysis shall be performed wherein the specimens shall conform to the required chemical compositions of vanadium, columbium, and molybdenum.
Scope
1.1 This specification covers hot-wrought, special quality microalloyed carbon steel bars intended for use as hot forging stock. The bars shall be hot-wrought, as-wrought, unless thermal treatment is necessary to ensure cold shearability.
1.2 The bars shall be furnished to chemical composition only. Chemical composition is based on standard carbon steel grades modified to include microalloying elements such as columbium (niobium), vanadium, or molybdenum. Desired mechanical properties are developed in the subsequent hot forging and controlled cooling operations.
1.3 Sections and sizes of bar steel available are covered in Specification A 29/A 29M.
1.4 Supplementary requirements S1 to S6 are provided for use when additional controls or requirements are desired. These shall apply only when specified on the purchase order.
1.5 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text and tables, SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification.
1.6 Unless the order specifies the applicable "M" specification designation, the material shall be furnished to the inch-pound units.
Keywords
carbon steel bars; microalloyed steel; steel bars; ICS Number Code 77.140.20 (Steels of high quality)
To find similar documents by ASTM Volume:
01.05 (Steel--Bars, Forgings, Bearing, Chain, Tool)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-A921/A921M-93(2005)
Revision Level
1993 R05 EDITION
Status
Superseded
Modification Type
Reapproval
Publication Date
March 1, 2005
Document Type
Specification
Page Count
3 pages
Committee Number
A01.15