Document Center is acquired by Nimonik

Scope

1.1 This test method covers a basic procedure of ultrasonically inspecting cylindrical forgings with bores from the bore surface.

1.2 This test method applies to the manual testing mode. It does not restrict the use of other testing modes, such as mechanized or automated.

1.3 This test method applies to cylindrical forgings having bore sizes equal to or greater than 2.5 in. (63.5 mm).

1.4 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

bore inspection; bored turbine rotor; forgings; ultrasonic examination; ICS Number Code 77.140.85 (Iron and steel forgings)

To find similar documents by ASTM Volume:

01.05 (Steel--Bars, Forgings, Bearing, Chain, Tool)

To find similar documents by classification:

77.140.85 (Iron and steel forgings)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.