ASTM-B162 › Standard Specification for Nickel Plate, Sheet, and Strip
The following bibliographic material is provided to assist you with your purchasing decision:
This specification covers rolled nickel (UNS N02200) and low-carbon nickel (UNS N02201) plate, sheet, and strip. The material shall conform to the chemical requirements for nickel, copper, iron, manganese, carbon, silicon, and sulfur. The material shall conform to the mechanical property requirements for tensile strength, yield strength, elongation, and Rockwell hardness. For deep drawing and spinning quality sheet and strip, the material shall conform to specified values for grain size and hardness properties. The material shall be uniform in quality and temper, smooth, commercially straight or flat, and free of injurious imperfections. Test methods (chemical analysis, mechanical test, grain size test) shall be performed in accordance to referenced ASTM documents itemized herein.
Scope
1.1 This specification2 covers rolled nickel (UNS N02200) and low-carbon nickel (UNS N02201)3 plate, sheet, and strip.
1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Keywords
ICS Number Code 77.150.40 (Nickel and chromium products)
To find similar documents by ASTM Volume:
To find similar documents by classification:
77.150.40 (Nickel and chromium products)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Customers who bought this document also bought:
ASTM-A240Standard Specification for Chromium and Chromium-Nickel Stainless Steel Plate, Sheet, and Strip for Pressure Vessels and for General Applications
ASTM-A484
Standard Specification for General Requirements for Stainless Steel Bars, Billets, and Forgings
ASTM-A276
Standard Specification for Stainless Steel Bars and Shapes
Document Number
ASTM-B162-99(2019)
Revision Level
1999 R19 EDITION
Status
Current
Modification Type
Reapproval
Publication Date
May 1, 2019
Document Type
Specification
Page Count
9 pages
Committee Number
B02.07