Document Center is acquired by Nimonik

Scope

1.1 This specification establishes the requirements for copper bar, bus bar, rod, and shapes for electrical and nonelectrical applications.

1.1.1 The products for electrical applications shall be made from the following coppers:

The product may be furnished from any copper listed unless otherwise specified in the contract or purchase order.

1.1.2 The product for nonelectrical applications shall be made from the following coppers:

The product may be furnished from any copper listed unless otherwise specified in the contract or purchase order.

1.2 The inch-pound units are standard for this specification.

1.3 This specification is the companion to SI (Metric) Specification B 187M; therefore no SI equivalents are presented herein.

Note 1—Material for hot forging will be found in Specification B 224.

Keywords

Bar; bus bar; copper; electrical conductors; embrittlement test; rod; shapes

To find similar documents by ASTM Volume:

02.01 (Copper and Copper Alloys)

To find similar documents by classification:

29.050 (Superconductivity and conducting materials)

77.150.30 (Copper products)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.