ASTM-B194 › Historical Revision Information
Standard Specification for Copper-Beryllium Alloy Plate, Sheet, Strip, and Rolled Bar
Show Complete Document History
The following bibliographic material is provided to assist you with your purchasing decision:
This specification establishes the requirements for plates, sheets, strips, and rolled bars of copper-beryllium alloy with Copper Alloy UNS Nos. C17000 and C17200. Materials shall be processed by the following conditions: solution heat treatment, solution heat treatment and cold working, precipitation heat treatment, and mill hardening. Specimens shall adhere to specified chemical composition, grain size, and grain count requirements. Alloys shall also undergo tensile and bend tests to evaluate their conformance to tensile strength, yield strength, elongation, and Rockwell hardness requirements.
Scope
1.1 This specification establishes the requirements for copper-beryllium alloy plate, sheet, strip, and rolled bar. The following alloys are specified:
Copper Alloy | Previously Used Commercial | Nominal Beryllium |
UNS No. | Designations | Content, % |
C17000 | Alloy 165 | 1.7 |
C17200 | Alloy 25 | 1.9 |
1.2 Unless otherwise specified in the contract or purchase order, Copper Alloy UNS No. C17200 shall be the alloy furnished.
1.3 Units—The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.4 The following hazard statement pertains only to the test method portions in the annex of this specification:
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Significance and Use
These test methods are primarily intended to test for compliance with composition specifications. It is assumed that all who use these test methods will be trained analysts capable of performing common laboratory procedures skillfully and safely. It is expected that work will be performed in a properly equipped laboratory.
Keywords
C17000; C17200; copper-beryllium; flat products; copper plate; copper rolled bar; copper strip; Copper alloy plate/sheet/strip/rolled bar--specifications; Copper-beryllium alloys--specifications; UNS C17000 (beryllium copper); UNS C17200 (beryllium copper); Copper alloy plate/sheet/strip/rolled bar--specifications; Copper-beryllium alloys--specifications; UNS C17000 (beryllium copper); UNS C17200 (beryllium copper); ICS Number Code 77.150.30 (Copper products)
To find similar documents by ASTM Volume:
02.01 (Copper and Copper Alloys)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-B194-08
Revision Level
2008 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
April 1, 2008
Document Type
Specification
Page Count
11 pages
Committee Number
B05.01