Document Center is acquired by Nimonik

Scope

1.1 This specification covers requirements for several types and grades of electrodeposited copper plus nickel plus chromium or nickel plus chromium coatings on steel, nickel plus chromium coatings on copper and copper alloys, and copper plus nickel plus chromium coatings on zinc alloys for applications where both appearance and protection of the basis metal against corrosion are important. Five grades of coatings are provided to correspond with the service conditions under which each is expected to provide satisfactory performance: namely, extended very severe, very severe, severe, moderate, and mild. Definitions and typical examples of these service conditions are provided in Appendix X1.

1.2 The following hazards caveat pertains only to the test methods portions, Appendixes X2, X3, and X4, of this specification: This standard does not purport to address all of safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

copper-nickel-chromium-electrodeposited coatings; electrodeposited coatings of Cu+Ni+Cr and Ni+Cr, spec., ; Electrodeposited Ni coatings; electrodeposited coatings of Cu+Ni+Cr and Ni+Cr, spec., ; Nickel-chromium alloys-electrodeposited; electrodeposited coatings of Cu+Ni+Cr and Ni+Cr, spec., ; Quenching; electrodeposited coatings of Cu+Ni+Cr and Ni+Cr, spec., ;Order Form; ICS Number Code 25.220.40 (Metallic coatings)

To find similar documents by ASTM Volume:

02.05 (Metallic and Inorganic Coatings; Metal Powders and Metal Powder Products)

To find similar documents by classification:

25.220.40 (Metallic coatings Including electrolytic depositions, cathodic coatings, autocatalytic coatings, etc.)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.