ASTM-B489 › Historical Revision Information
Standard Practice for Bend Test for Ductility of Electrodeposited and Autocatalytically Deposited Metal Coatings on Metals
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This practice covers a test procedure for determining the ductility of electrodeposited and autocatalytically deposited coatings on sheet or strip basis metals. The purpose of the test is to determine the resistance of metal coatings to cracking during distortion.
1.2 Test Methods E8 can be used if the coatings are too ductile and require mandrels too small to be practical.
1.3 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
autocatalytic deposits; ductility tests; electrodeposits; ICS Number Code 25.220.40 (Metallic coatings)
To find similar documents by ASTM Volume:
02.05 (Metallic and Inorganic Coatings; Metal Powders and Metal Powder Products)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-B489-85(1992)e1
Revision Level
1985 R92(E1) EDITION
Status
Superseded
Modification Type
Reapproval
Publication Date
Jan. 1, 1992
Document Type
Practice
Page Count
3 pages
Committee Number
B08.10