ASTM-B569 › Standard Specification for Brass Strip in Narrow Widths and Light Gage for Heat-Exchanger Tubing
The following bibliographic material is provided to assist you with your purchasing decision:
This specification establishes the requirements for brass strips in narrow widths and light gages produced from Copper Alloy UNS Nos. C23000, C26000, and C26130 to be used in heat exchanger tubing. The material for manufacture shall be a cast bar, cake, or slab of such purity and soundness as to be suitable for processing by hot working, cold working, and annealing to produce a uniform wrought structure in the finished product. Products shall be produced in tempers H01 (¼ hard), H02 (½ hard), O81 (annealed-to-temper, ¼ hard), and O82 (annealed-to-temper, ½ hard). Products shall be sampled and prepared, then tested accordingly to examine their conformance to dimensional (mass, thickness, width, and straightness), mechanical (tensile and yield strengths, and elongation), chemical composition, and grain size requirements.
Changes from the previous issue
A redline edition is available for this document, with all changes visible. Ask Document Center Inc. for more information.
Scope
1.1 This specification establishes the requirements for brass strip in narrow widths and light gages produced from Copper Alloys Nos. C23000, C26000, and C26130.2
Note 1: This product is commonly used for the manufacture of thin-wall tubes for water passages in heat exchangers for internal combustion engines and other closed-system heat sources.
1.2 Units—The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units, which are provided for information only and are not considered standard.
1.2.1 Exception—Grain size and chemical analysis sampling are stated in SI units.
1.3 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Keywords
brass strip; heat exchanger tubing; internal combustion engine; strip in light gage; strip in narrow width; UNS No. C23000; UNS No. C26000; UNS No. C26130;; ICS Number Code 77.150.30 (Copper products)
To find similar documents by ASTM Volume:
02.01 (Copper and Copper Alloys)
To find similar documents by classification:
To find similar documents by Federal Supply Class Code:
FSC 6130 (Converters, Electrical, Nonrotating)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-B569-19
Revision Level
2019 EDITION
Status
Current
Modification Type
Revision
Publication Date
April 1, 2019
Document Type
Specification
Page Count
5 pages
Committee Number
B05.01