ASTM-C1019 Historical Revision Information
Standard Test Method for Sampling and Testing Grout

ASTM-C1019 - 1998A EDITION - SUPERSEDED
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:

Standard Test Method for Sampling and Testing Grout for Masonry
ORDER

Scope

1.1 This test method covers procedures for both field and laboratory sampling and compression testing of grout used in masonry construction.

Note 1—The testing agency performing this test method should be evaluated in accordance with Practice C1093.

1.2 The values stated in inch-pound units are to be regarded as the standard.

1.3 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

cementitious; compressive strength; grout; masonry units

To find similar documents by ASTM Volume:

04.05 (Chemical-Resistant Nonmetallic Materials; Vitrified Clay Pipe; Concrete Pipe; Fiber-Reinforced Cement Products; Mortars and Grouts; Masonry; Precast Concrete)

To find similar documents by classification:

91.100.10 (Cement. Gypsum. Lime. Mortar)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ASTM-C1019-98a

Revision Level

1998A EDITION

Status

Superseded

Modification Type

Revision

Publication Date

Sept. 10, 1998

Document Type

Test Method

Page Count

3 pages

Committee Number

C12.02