ASTM-C1025 › Standard Test Method for Modulus of Rupture in Bending of Electrode Graphite
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers determination of the modulus of rupture in bending of specimens cut from graphite electrodes using a simple square cross section beam in four-point loading at room temperature.
1.2 The values stated in SI units are to be regarded as standard.
1.3 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
carbon; electrode graphite; flexural strength; graphite; modulus of rupture; ICS Number Code 71.100.99 (Other products of the chemical industry)
To find similar documents by ASTM Volume:
05.05 (Combustion Characteristics; Manufactured Carbon and Graphite Products; Catalysts)
To find similar documents by classification:
71.100.99 (Other products of the chemical industry)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-C1025-15R20
Revision Level
2015 R20 EDITION
Status
Current
Modification Type
Reapproval
Publication Date
June 17, 2020
Document Type
Test Method
Page Count
3 pages
Committee Number
D02.F0