ASTM-C1218 › Historical Revision Information
Standard Test Method for Water-Soluble Chloride in Mortar and Concrete
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method provides procedures for the sampling and analysis of hydraulic-cement mortar or concrete for chloride that is water soluble under the conditions of test.
1.2 The text of this standard references notes and footnotes that provide explanatory information. These notes and footnotes shall not be considered as requirements of this standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
1.4 The values stated in either SI units or inch-pound units are to be regarded separately as a standard. Within the text, the inch-pound units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system shall be used independently of the other.
Keywords
chloride; chloride content; concrete; mortar; water-soluble chloride; ICS Number Code 91.100.10 (Cement. Gypsum. Lime. Mortar)
To find similar documents by ASTM Volume:
04.02 (Concrete and Aggregates)
To find similar documents by classification:
91.100.10 (Cement. Gypsum. Lime. Mortar)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-C1218-92e1
Revision Level
1992(E1) EDITION
Status
Superseded
Publication Date
Feb. 1, 1993
Document Type
Test Method
Page Count
3 pages
Committee Number
C09.69