Document Center is acquired by Nimonik

Scope

1.1 This specification covers structural clay load-bearing facing tile and facing brick and other "solid masonry units" made from clay, shale, fire-clay, or mixtures thereof, with or without the addition of grog or other mixtures, having a finish consisting of a ceramic glaze fused to the body at above 1500F (655C) making them inseparable, excluding natural salt-glazed ware. Two grades, based on permissible variation in face dimensions, and two types are covered, as follows:

1.1.1 Grade S (select), for use with comparatively narrow mortar joints.

1.1.2 Grade SS (select sized or ground edge), for use where variation of face dimension must be very small.

1.1.3 Type I (single-faced units), for general use where only one finished face will be exposed.

1.1.4 Type II (two-faced units), for use where two opposite finished faces will be exposed.

1.2 The property requirements of this specification apply at the time of purchase. The use of results from testing of brick and tile extracted from masonry structures for determining conformance or nonconformance to the property requirements (Section 5) of this standard is beyond the scope of this specification.

1.3 Brick and tile covered by this specification are manufactured from clay, shale, or similar naturally occurring substances and subjected to a heat treatment at elevated temperatures (firing). The heat treatment must develop sufficient fired bond between the particulate constituents to provide the strength requirements of this specification. (See firing and fired bond in Terminology C 43.)

1.4 The text of this standard references notes and footnotes which provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of the standard.

1.5The following precautionary caveat pertains only to the test portion (Section 16) of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

brick; ceramic glaze; clay; glaze properties; masonry construction; physical properties; shale; tile; ICS Number Code 81.080 (Refractories)

To find similar documents by ASTM Volume:

04.05 (Chemical-Resistant Nonmetallic Materials; Vitrified Clay Pipe; Concrete Pipe; Fiber-Reinforced Cement Products; Mortars and Grouts; Masonry; Precast Concrete)

To find similar documents by classification:

81.080 (Refractories Including ceramic refractories)

91.100.23 (Ceramic tiles)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.