ASTM-C1604 › Standard Test Method for Obtaining and Testing Drilled Cores of Shotcrete
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers obtaining, preparing, and testing cores drilled from shotcrete for length, compressive strength, or splitting tensile strength determinations.
1.2 The values stated in either inch-pound units or SI units shall be regarded separately as standard. SI units are shown in brackets. The values stated in each system may not be exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the standard.
1.3 The text of this standard references notes and footnotes that provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of the standard.
This standard does not purport to address the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
compressive strength; core; shotcrete; splitting tensile strength; ICS Number Code 91.100.30 (Concrete and concrete products)
To find similar documents by ASTM Volume:
04.02 (Concrete and Aggregates)
To find similar documents by classification:
91.100.30 (Concrete and concrete products Including admixtures)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Customers who bought this document also bought:
ASTM-C1140Standard Practice for Preparing and Testing Specimens from Shotcrete Test Panels
Document Number
ASTM-C1604_C1604M-05R19
Revision Level
2005 R19 EDITION
Status
Current
Modification Type
New
Publication Date
Dec. 15, 2019
Document Type
Test Method
Page Count
6 pages
Committee Number
C09.46