ASTM-C230 › Historical Revision Information
Standard Specification for Flow Table for Use in Tests of Hydraulic Cement
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This specification coves requirements for the flow table and accessory apparatus (Note 1) used in making flow tests for consistency of mortars in tests of hydraulic cement.
Note 1--To help clarify the design of the flow table and accessory apparatus see the drawing in Fig. 1 [Fig. 2]. This drawing is for informational purposes only.
1.2 The values stated in either inch-pound units or SI units shall be regarded separately as standard. The values stated are not exact equivalents; therefore, each system must be used independently of the other. It is permissible to use an inch-pound caliper and mold with a SI flow table or a SI caliper and mold with an inch-pound flow table. It is not permissible to mix a SI mold with an inch-pound caliper or an inch-pound mold with a SI caliper.
Keywords
hydraulic cement; flow table; consistency of mortars
To find similar documents by ASTM Volume:
To find similar documents by classification:
91.100.10 (Cement. Gypsum. Lime. Mortar)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-C0230_C0230M-21
Revision Level
2021 EDITION
Status
Superseded
Modification Type
Editorially changed
Publication Date
Jan. 29, 2021
Document Type
Specification
Page Count
7 pages
Committee Number
C01.22