ASTM-C308 › Historical Revision Information
Standard Test Methods for Working, Initial Setting, and Service Strength Setting Times of Chemical-Resistant Resin Mortars
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 These test methods cover the determination of the working, initial setting, and service strength setting times of chemical-resistant resin mortars.
1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Significance and Use
4.1 These test methods offer a means of determining the working time, initial setting time and service strength setting time of chemical-resistant resin mortars. The results obtained should serve as a guide in, but not as the sole basis for, selection of a chemical-resistant mortar for a particular application.
Keywords
chemical-resistant mortars; service strength setting time; initial setting time; working time; ICS Number Code 91.100.10 (Cement. Gypsum. Lime. Mortar)
To find similar documents by ASTM Volume:
06.02 (Paint -- Products and Applications; Protective Coatings; Pipeline Coatings)
To find similar documents by classification:
91.100.10 (Cement. Gypsum. Lime. Mortar)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-C308-00(2012)e1
Revision Level
2000 R12(E1) EDITION
Status
Superseded
Modification Type
Editorially changed
Publication Date
Sept. 1, 2012
Document Type
Test Method
Page Count
3 pages
Committee Number
D01.46