ASTM-C353 › Standard Test Method for Adhesion of Dried Thermal Insulating or Finishing Cement (Withdrawn 2002)
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers the measurement of the relative adhesion of dried thermal insulating or finishing cement to a particular test surface. While this test method is valuable in rating these products generally, the adhesion of cement to one type of surface cannot be construed as being fully indicative of its adhesion to another type of surface.
1.2 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
finishing cement; thermal insulating; wet adhesion
To find similar documents by ASTM Volume:
04.06 (Thermal Insulation; Building and Environmental Acoustics)
To find similar documents by classification:
91.100.10 (Cement. Gypsum. Lime. Mortar)
This document comes with our free Notification Service, good for the life of the document.
This document is available in Paper format.
Document Number
ASTM-C353-97
Revision Level
1997 EDITION
Status
Superseded
Modification Type
Withdrawn
Publication Date
May 10, 1997
Document Type
Test Method
Page Count
3 pages
Committee Number
C16.32