Document Center is acquired by Nimonik

Scope

1.1 These test methods cover procedures for sampling and testing mastics and coatings for use as weather and vapor barrier finishes on thermal insulations and for other accessory use.

1.2 The values stated in inch-pound units are to be regarded as the standard. The metric equivalents of inch-pound units may be approximate.

1.3 The test methods appear in the following order:

Section Sampling 3 Uniformity and Storage Stability 4 Stability Under Freezing 5 Density and Weight per Gallon 6 Consistency 7 Solids Content 8 Content of Volatiles and Coverage of Mastics and Coatings 9 Build 10 Drying Time 11 Flash Point 12

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

coatings; consistency; density; mast; thermal insulation

To find similar documents by ASTM Volume:

04.06 (Thermal Insulation; Building and Environmental Acoustics)

To find similar documents by classification:

27.220 (Heat recovery. Thermal insulation This group includes standards for general use Thermal insulation of buildings, see 91.120.10)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.