ASTM-C488 › Standard Test Method for Conducting Exterior Exposure Tests of Finishes for Thermal Insulation
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers out-of-doors exposure testing of finishes that are normally field-applied to thermal insulation which may include joints or joint sealants, or both. Such exposure may be essential prior to the determination of certain physical properties. This test method may also indicate compatibility problems between the joint sealant and the finish as well as the ability of the finish to span a dry joint. This test method is not intended to evaluate mildew resistance, efflorescence, or chemical resistance.
Note-For testing free plastic films, see Practice D1435.1.2 This test method does not prescribe the method of application, test duration, or inspection intervals.
1.3 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
1.4 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are provided for information only.
Keywords
coatings; exterior exposure test; test procedure; vapor barrier finishes; ICS Number Code 27.220 (Heat recovery. Thermal insulation)
To find similar documents by ASTM Volume:
04.06 (Thermal Insulation; Building and Environmental Acoustics)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-C0488-16R23
Revision Level
2016 R23 EDITION
Status
Current
Modification Type
Reapproval
Publication Date
Sept. 26, 2023
Document Type
Test Method
Page Count
3 pages
Committee Number
C16.33