ASTM-D1106 › Standard Test Method for Acid-Insoluble Lignin in Wood,
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method3 covers the determination of the acid-insoluble lignin content of wood.
1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. Specific precautionary statements are given in 6.1.
1.3 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Significance and Use
4.1 Wood contains approximately 20 to 30 % lignin. Removal of the lignin is the primary objective of pulping and bleaching procedures. Determination of the lignin content provides information for the evaluation and application of these processes.
Keywords
acid-insoluble lignin; wood ;
To find similar documents by ASTM Volume:
To find similar documents by classification:
79.040 (Wood, sawlogs and sawn timber)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D1106-21
Revision Level
2021 EDITION
Status
Current
Modification Type
Revision
Publication Date
March 17, 2021
Document Type
Test Method
Page Count
3 pages
Committee Number
D07.01