ASTM-D1864 › Historical Revision Information
Standard Test Method for Moisture in Mineral Aggregate Used on Built-Up Roofs
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers the determination of moisture in mineral aggregate for use on built-up roofs.
1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Significance and Use
4.1 This test method measures the moisture in mineral aggregate required by Specification D1863/D1863M.
Keywords
built-up roofs; mineral aggregate; moisture;
To find similar documents by ASTM Volume:
04.04 (Roofing and Waterproofing)
To find similar documents by classification:
91.100.15 (Mineral materials and products Including earth, sands, clay, slates, stones, etc.)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D1864/D1864M-89(2017)
Revision Level
1989 R17 EDITION
Status
Superseded
Modification Type
Reapproval
Publication Date
Jan. 15, 2017
Document Type
Test Method
Page Count
2 pages
Committee Number
D08.03