ASTM-D2010 Historical Revision Information
Standard Test Methods for Evaluation of Total Sulfation Activity in the Atmosphere by the Lead Dioxide Technique

ASTM-D2010 - 1993 EDITION - SUPERSEDED
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:

Standard Test Methods for Evaluation of Total Sulfation Activity in the Atmosphere by the Lead Dioxide Technique
ORDER

Scope

1.1 These test methods describe the evaluation of the total sulfation activity in the atmosphere. Because of its oxidizing power, lead dioxide (PbO2) converts not only sulfur dioxide (SO2), but other compounds, such as mercaptans and hydrogen sulfide, into sulfate. It fixes sulfur trioxide and sulfuric acid mist present in the atmosphere (see Note).

1.2 Test Method A describes the use of a PbO2 candle, and Test Method B describes that of a PbO2 sulfation plate.

1.3 These test methods provide a weighted average effective SO2 level for a 30-day interval.

1.4 The results of these test methods correlate approximately with volumetric SO2 concentrations, although the presence of dew or condensed moisture tends to enhance the capture of SO2 onto the candle or plate.

1.5 The values stated in SI units shall be regarded as the standard. The values given in parentheses are for information only and may be approximate.

Note-It has been shown that the rate constant of the chemical reaction between SO2 and PbO2 is independent of the concentration of SO2 up to levels of 1000 ppm, if 15% or less of the PbO2 has been reduced (1). 15% of the PbO2 is equivalent to 11 to 12 mg of SO2/cm per day.

1.6 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific precautionary statements, see Section 8.

Keywords

atmospheres; Huey plates; lead dioxide; lead dioxide candles; sampling; sulfation; sulfation plates; sulfur dioxide; ICS Number Code 13.040.20 (Ambient atmospheres)

To find similar documents by ASTM Volume:

11.07 (Atmospheric Analysis)

To find similar documents by classification:

13.040.20 (Ambient atmospheres Including indoor air)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ASTM-D2010/D2010M-93

Revision Level

1993 EDITION

Status

Superseded

Modification Type

Revision

Publication Date

July 15, 1993

Document Type

Test Method

Page Count

6 pages

Committee Number

D22.03