ASTM-D2457 › Historical Revision Information
Standard Test Method for Specular Gloss of Plastic Films and Solid Plastics
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method describes procedures for the measurement of gloss of plastic films and solid plastics, both opaque and transparent. It contains three separate gloss angles (Note 1):
1.1.1 60-deg, recommended for intermediate-gloss films,
1.1.2 20-deg, recommended for high-gloss films, and
1.1.3 45-deg, recommended for intermediate and low-gloss films.
Note 1-The 60-deg and 20-deg apparatus and method of measurement duplicate those in Test Method D 523; those for the 45° procedure are similarly taken from Test Method C 346.
1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Note 2- There is no similar or equivalent ISO standard.
Keywords
gloss; plastic films; solid plast; ICS Number Code 83.140.10 (Films and sheets)
To find similar documents by ASTM Volume:
08.01 (Plastics (I): D256 - D3159)
08.02 (Plastics (II): D3222 - D5083)
To find similar documents by classification:
83.140.10 (Films and sheets Including plates)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D2457-97
Revision Level
1997 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
Jan. 10, 1997
Document Type
Test Method
Page Count
5 pages
Committee Number
D20.40