ASTM-D2463 › Historical Revision Information
Standard Test Method for Drop Impact Resistance of Blow-Molded Thermoplastic Containers
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method provides measures of the drop impact resistance of blow-molded thermoplastic containers as a summation of the effects of material, manufacturing conditions, container design, and perhaps other factors.
1.2 Three procedures are provided as follows:
1.2.1 Procedure A, Static Drop Height Method—This procedure is particularly useful for quality control since it is quick.
1.2.2 Procedure B, Bruceton, Staircase Method—This procedure is used to determine the mean failure height and the standard deviation of the distribution.
1.3 The values stated in SI units are to be regarded as standard. The inch-pound units given in parentheses are for information only.
Note 1—There is no similar or equivalent ISO standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
blow-molded containers; drop impact; plastic containers
To find similar documents by ASTM Volume:
08.01 (Plastics (I): D256 - D3159)
08.02 (Plastics (II): D3222 - D5083)
To find similar documents by classification:
83.080.20 (Thermoplastic materials)
83.140.99 (Other rubber and plastics products)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D2463-95
Revision Level
1995 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
Nov. 10, 1995
Document Type
Test Method
Page Count
5 pages
Committee Number
D20.20