ASTM-D2517 › Historical Revision Information
Standard Specification for Reinforced Epoxy Resin Gas Pressure Pipe and Fittings
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This specification covers requirements and methods of test for materials, dimensions and tolerances, hydrostatic-burst strength, chemical resistance, and longitudinal tensile properties, for reinforced epoxy resin pipe and fittings for use in gas mains and services for direct burial and insertion applications. The pipe and fittings covered by this specification are intended for use in the distribution of natural gas, petroleum fuels (propane-air and propane-butane vapor mixtures), manufactured and mixed gases where resistance to gas permeation, toughness, resistance to corrosion, aging, and deterioration from water, gas, and gas additives are required. Methods of marking are also given. Design considerations are discussed in Appendix X1.
1.2 The values in SI units are to be regarded as the standard.
1.3 The following safety hazards caveat pertains only to the test method portion, Section 8, of this specification:
There is no similar or equivalent ISO standard.
1.4 A recommended inplant quality control program is given in Appendix X2.
Keywords
filament wound; compression molded; configuration of joining system; rapture srength; crush strength; chemical resistance; apparent tensile properties; adhesive
To find similar documents by ASTM Volume:
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D2517-00
Revision Level
2000 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
July 10, 2000
Document Type
Specification
Page Count
5 pages
Committee Number
D20.23