Document Center is acquired by Nimonik

Scope

1.1 These test methods cover the determination of strength values for clear wood of different species in the unseasoned condition, unadjusted for end use, applicable to the establishment of working stresses for different solid wood products such as lumber, laminated wood, plywood, and round timbers. Presented are:

1.1.1 Procedures by which test values obtained on small clear specimens may be combined with density data from extensive forest surveys to make them more representative,

1.1.2 Guidelines for the interpretation of the data in terms of assigned values for combinations of species or regional divisions within a species to meet special marketing needs, and

1.1.3 Information basic to the translation of the clear wood values into working stresses for different solid wood products for different end uses.

1.1.4 For species where density survey data are not as yet available for the reevaluation of average strength properties, the presently available data from tests made under the sampling methods and procedures of Methods D143, or Practice E105, are provided with appropriate provision for their application and use. Because of the comprehensive manner in which the density survey is undertaken, it follows that the reevaluated strength data are intended to be representative of the forest stand, or rather large forest subdivisions.

1.1.5 Some useful mechanical properties (tensile strengths parallel and perpendicular to grain and modulus of rigidity for a longitudinal-transverse plane) have not been extensively evaluated. Methods are described for estimating these properties by their relation to other properties.

1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

clear wood strength values; compression testing;emwood/wood products; dry to green clear wood properties; grading;emwood products; modulus of elasticity; emwood products; modulus of rupture (MOR); shear testing;emwood products; specific gravity; emwood products; strength values (wood); stress grading;emlumber; Structural wood products; Timber; Visual grading (of lumber); Wood products;emstructural; establishing clear wood strength values (for unseasoned lumber/laminated timber/plywood/round timbers/solid wood products)

To find similar documents by ASTM Volume:

04.10 (Wood)

To find similar documents by classification:

79.040 (Wood, sawlogs and sawn timber)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.