ASTM-D2782 Historical Revision Information
Standard Test Method for Measurement of Extreme-Pressure Properties of Lubricating Fluids (Timken Method)

ASTM-D2782 - 2002 R08 EDITION - SUPERSEDED
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:

Standard Test Method for Measurement of Extreme-Pressure Properties of Lubricating Fluids (Timken Method)
ORDER

Scope

1.1 This test method covers the determination of the load-carrying capacity of lubricating fluids by means of the Timken Extreme Pressure Tester.

Note 1—This test method is suitable for testing fluids having a viscosity of less than about 5000 cSt (5000 mm2/s) at 40°C. For testing fluids having a higher viscosity, refer to Note 5 in 9.1.

1.2 The values stated in SI units are to be regarded as standard. Because the equipment used in this test method is available only in inch-pound units, SI units are omitted when referring to the equipment and the test specimens.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific warning statements are given in 7.1, 7.2, 8.1, 8.2, 9.4, and 9.9.

Significance and Use

This test method is used widely for the determination of extreme pressure properties for specification purposes. Users are cautioned to carefully consider the precision and bias statements herein when establishing specification limits.

Keywords

EP; extreme pressure; load carrying capacity; lubricant; Timken; EP (extreme-pressure) lubricants; Load-carrying capacity--lubricants; Loading tests--petroleum products; Lubricants (fluid); Lubricating oils; Nonpetroleum hydraulic fluids; Pressure testing--petroleum products; Timken test method; ICS Number Code 75.100 (Lubricants, industrial oils and related products)

To find similar documents by ASTM Volume:

05.01 (Petroleum Products and Lubricants (I): D56 - D3710)

To find similar documents by classification:

75.080 (Petroleum products in general)

75.100 (Lubricants, industrial oils and related products Including mineral oils, fluids for metal working and for temporary protection against corrosion Lubrication systems, see 21.260 Insulating oils, see 29.035.40)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ASTM-D2782-02(2008)

Revision Level

2002 R08 EDITION

Status

Superseded

Modification Type

Reapproval

Publication Date

Aug. 1, 2008

Document Type

Test Method

Page Count

12 pages

Committee Number

D02.L0.11