ASTM-D2782 › Historical Revision Information
Standard Test Method for Measurement of Extreme-Pressure Properties of Lubricating Fluids (Timken Method)
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers the determination of the load-carrying capacity of lubricating fluids by means of the Timken Extreme Pressure Tester.
Note 1: This test method is suitable for testing fluids having a viscosity of less than about 5000 cSt (5000 mm2/s) at 40 °C. For testing fluids having a higher viscosity, refer to Note 5 in 9.1.
1.2 The values stated in SI units are to be regarded as standard. Because the equipment used in this test method is available only in inch-pound units, SI units are omitted when referring to the equipment and the test specimens.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. Specific warning statements are given in 7.1, 7.2, 8.1, 8.2, 9.4, and 9.9.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Significance and Use
5.1 This test method is used widely for the determination of extreme pressure properties for specification purposes. Users are cautioned to carefully consider the precision and bias statements herein when establishing specification limits.
Keywords
EP; extreme pressure; load carrying capacity; lubricant; Timken;
To find similar documents by ASTM Volume:
05.01 (Petroleum Products and Lubricants (I): D56 - D3710)
To find similar documents by classification:
75.080 (Petroleum products in general)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D2782-20
Revision Level
2020 EDITION
Status
Current
Modification Type
Revision
Publication Date
Oct. 6, 2020
Document Type
Test Method
Page Count
12 pages
Committee Number
D02.L0.11