Document Center is acquired by Nimonik

Scope

1.1 This practice is a guide for removing test specimens from existing built-up roofing systems in the field and for determining the approximate quantities of the components of that specimen (Note 1). Components determined may be:

1.1.1 Insulation components when they are part of the roof membrane system,

1.1.2 Plies of roofing felt,

1.1.3 Interply layers of bituminous material,

1.1.4 Top coating, and

1.1.5 Surfacing. Note 1 - This procedure is for the investigation of existing roofs and is not intended for new construction inspection.

1.2 This practice is applicable to both 914-mm (36-in.) and 1000-mm (39 3/8-in.) wide felt rolls.

1.3 The values stated in SI (metric) units are to be regarded as standard.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific precautionary information, see 6.3.2.1.

Significance and Use

This practice is for the sampling and analysis of existing built-up roof systems. For roofs under construction, use Practice D 3617.

Keywords

decking; felts; insulation; interply bituminous material; lap spacing; plies; surfacing; top coating; ICS Number Code 91.100.50 (Binders. Sealing materials)

To find similar documents by ASTM Volume:

04.04 (Roofing and Waterproofing)

To find similar documents by classification:

91.100.50 (Binders. Sealing materials Including geomembranes, asphalts for buildings, etc.)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.