ASTM-D2998 › Standard Test Method for Polyhydric Alcohols in Alkyd Resins (Withdrawn 2004)
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers the qualitative and quantitative determination of the polyols in alkyl resins, including resin- and polymer-modified alkyds. Quantities as low as 0.5% may be detected and measured.
1.2 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For a specific hazard statement, see Section 7.
Keywords
alkyd resins; gas chromatography; polyhydric alcohols; polyols; ICS Number Code 83.080.10 (Thermosetting materials)
To find similar documents by ASTM Volume:
To find similar documents by classification:
83.080.10 (Thermosetting materials Including ebonite Silicones, see 71.100.55)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D2998-89(1996)e1
Revision Level
1989 R96(E1) EDITION
Status
Cancelled
Modification Type
Withdrawn
Publication Date
Nov. 1, 1996
Document Type
Test Method
Page Count
3 pages
Committee Number
D01.33