ASTM-D3120 › Historical Revision Information
Standard Test Method for Trace Quantities of Sulfur in Light Liquid Petroleum Hydrocarbons by Oxidative Microcoulometry
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers the determination of sulfur in the range from 3.0 to 100 ppm (μg/g) in light liquid hydrocarbons boiling in the range from 26 to 274°C (80 to 525°F).
1.2 This test method may be extended to liquid materials with higher sulfur concentrations by appropriate dilution.
1.3 The preferred units are micrograms per grams. Values stated in SI units are to be regarded as the standard. Values in inch-pound units are for information only.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements, see 6.3, 6.4, 6.8, and 6.10.
Keywords
light hydrocarbons; microcoulometry; sulfur; ICS Number Code 75.080 (Petroleum products in general)
To find similar documents by ASTM Volume:
05.01 (Petroleum Products and Lubricants (I): D56 - D3710)
To find similar documents by classification:
75.080 (Petroleum products in general)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D3120-96(2002)e1
Revision Level
1996 R02(E1) EDITION
Status
Superseded
Modification Type
Reapproval with Ed Change
Publication Date
Sept. 1, 2002
Document Type
Test Method
Page Count
6 pages
Committee Number
D02.03