ASTM-D3174 Historical Revision Information
Standard Test Method for Ash in the Analysis Sample of Coal and Coke from Coal

ASTM-D3174 - 2004 EDITION - SUPERSEDED
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:

Standard Test Method for Ash in the Analysis Sample of Coal and Coke from Coal
ORDER

Scope

1.1 This test method covers the determination of the inorganic residue as ash in the analysis sample of coal or coke as prepared in accordance with Method D 2013 or Practice D 346. The results obtained can be applied as the ash in the proximate analysis, Practice D 3172, and in the ultimate analysis, Practice D 3176. For the determination of the constituents in ash, reference is made to Test Methods D 2795 and D 3682. See Terminology D 121 for definition of ash.

1.2 The values stated in SI units are to be regarded as the standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Significance and Use

Ash, as determined by this test method, is the residue remaining after burning the coal and coke. Ash obtained differs in composition from the inorganic constituents present in the original coal. Incineration causes an expulsion of all water, the loss of carbon dioxide from carbonates, the conversion of iron pyrites into ferric oxide, and other chemical reactions. Ash, as determined by this test method, will differ in amount from ash produced in furnace operations and other firing systems because incineration conditions influence the chemistry and amount of the ash. References for correcting ash results determined by this test method to a mineral-matter-free basis are listed in Classification D 388, Section 8.

Keywords

ash; coal; coke; ICS Number Code 75.160.10 (Solid fuels)

To find similar documents by ASTM Volume:

05.04 (Petroleum Products and Lubricants (IV): D6973 - latest)

05.06 (Gaseous Fuels; Coal and Coke)

To find similar documents by classification:

75.160.10 (Solid fuels Including coal products, coke, peat, wood, derivatives of coal pyrolysis, etc. Coals, see 73.040)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ASTM-D3174-04

Revision Level

2004 EDITION

Status

Superseded

Modification Type

Revision

Publication Date

July 1, 2004

Document Type

Test Method

Page Count

5 pages

Committee Number

D05.21