ASTM-D3204 › Standard Specification for Preformed Cellular Plastic Joint Fillers for Relieving Pressure (Withdrawn 2004)
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This specification covers preformed pressure-relief joint fillers of the following two types made from cellular plastic materials having suitable compressibility and nonextruding characteristics.
1.1.1 Type I, closed cell polyethylene, and
1.1.2 Type II, open cell polyurethane.
1.2 These joint fillers are intended for use in concrete pavements in full-depth joints measuring approximately 4.0 in. (102 mm) in width to relieve stress or avoid potential distress in adjacent structures or pavements.
1.3 The values stated in inch-pound units are to be regarded as the standard.
Keywords
cellular plastic; joint fillers; pressure relief joints; ICS Number Code 83.100 (Cellular materials)
To find similar documents by ASTM Volume:
04.03 (Road and Paving Materials; Vehicle-Pavement Systems)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D3204-93(2003)
Revision Level
1993 R03 EDITION
Status
Cancelled
Modification Type
Withdrawn
Publication Date
Nov. 1, 2003
Document Type
Specification
Page Count
2 pages
Committee Number
D04.34