ASTM-D3261 › Historical Revision Information
Standard Specification for Butt Heat Fusion Polyethylene (PE) Plastic Fittings for Polyethylene (PE) Plastic Pipe and Tubing
The following bibliographic material is provided to assist you with your purchasing decision:
This specification covers polyethylene (PE) butt fusion fittings for use with polyethylene pipe (IPS and ISO) and tubing (CTS). Included are requirements for materials, workmanship, dimensions, marking, sustained pressure, and burst pressure. Pressure strength test shall be performed to meet the requirements prescribed.
Scope
1.1 This specification covers polyethylene (PE) butt fusion fittings for use with polyethylene pipe (IPS, DIPS, and ISO) and tubing (CTS). Included are requirements for materials, workmanship, dimensions, marking, sustained pressure, and burst pressure.
1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
Keywords
butt fusion fittings; fittings; polyethylene fittings; polyethylene pipe; polyethylene tubing; ICS Number Code 23.040.20 (Plastic pipes); 23.040.45 (Plastic fittings)
To find similar documents by ASTM Volume:
08.04 (Plastic Piping Systems)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D3261-12
Revision Level
2012 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
Dec. 1, 2012
Document Type
Specification
Page Count
8 pages
Committee Number
F17.10