ASTM-D3326 › Historical Revision Information
Standard Practice for Preparation of Samples for Identification of Waterborne Oils
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This practice covers the preparation for analysis of waterborne oils recovered from water. The identification is based upon the comparison of physical and chemical characteristics of the waterborne oils with oils from suspect sources. These oils may be of petroleum or vegetable/animal origin, or both. Seven procedures are given as follows:
| Sections | |
| Procedure A (for samples of more than 50-mL volume containing significant quantities of hydrocarbons with boiling points above 280°C) | 8 to 12 |
| Procedure B (for samples containing significant quantities of hydrocarbons with boiling points above 280°C) | 13 to 17 |
| Procedure C (for waterborne oils containing significant amounts of components boiling below 280°C and to mixtures of these and higher boiling components) | 18 to 22 |
| Procedure D (for samples containing both petroleum and vegetable/animal derived oils) | 23 to 27 |
| Procedure E (for samples of light crudes and medium distillate fuels) | 28 to 34 |
| Procedure F (for thin films of oil-on-water) | 35 to 39 |
| Procedure G (for oil-soaked samples) | 40 to 44 |
1.2 Procedures for the analytical examination of the waterborne oil samples are described in Practice D 3415 and Test Methods D 3327, D 3328, D 3414, and D 3650. Refer to the individual oil identification test methods for the sample preparation method of choice. The deasphalting effects of the sample preparation method should be considered in selecting the best methods.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific caution statements are given in Sections 6 and 32.
Keywords
identification; oil spill; preparation; sample; waterborne oil; ICS Number Code 75.080 (Petroleum products in general)
To find similar documents by ASTM Volume:
To find similar documents by classification:
75.080 (Petroleum products in general)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D3326-84
Revision Level
1984 EDITION
Status
Superseded
Modification Type
Reapproval with Ed Change
Publication Date
Oct. 26, 1984
Document Type
Practice
Page Count
10 pages
Committee Number
D19.06