ASTM-D3595 › Historical Revision Information
Standard Specification for Polychlorotrifluoroethylene (PCTFE) Extruded Plastic Sheet and Film

ASTM-D3595 - 2002 R07 EDITION - SUPERSEDED
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:


This specification covers four types of polychlorotrifluoroethylene extruded plastic sheet and film: Type I - a transparent film with high and low moisture vapor transmission rate; Type II - a dimensionally stable transparent sheet and film with low moisture vapor transmission rate; Type III - a dimensionally stable transparent film with very low moisture vapor transmission rate; and Type IV - a low crystalline transparent film with high ductility and extremely low moisture vapor transmission rate. The specimens shall be manufactured from polychlorotrifluoroethylene plastics that consist of at least 90% chlorotrifluoethylene and 10% chemical modification such as co-monomers but not colorants, fillers, plasticizers, or mechanical blends of other resins. Tests shall be conducted to determine the specific property values of the specimen which shall conform to the tensile strength, elongation, dimensional stability or shrinkage, and moisture vapor transmission rate requirements.

ORDER

Scope

1.1 This specification covers extruded sheet and film in thicknesses from 0.015 to 0.25 mm (0.0006 to 0.01 in.).

1.2 The values stated in SI units shall be regarded as the standard.

The following precautionary statement pertains only to the test methods portion, Section of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Note 1

There is no ISO equivalent specification to this specification.

Keywords

chlorofluorocarbon plastics; copolymer; extruded PCTFE; fluorocarbon polymer; fluoropolymers; homopolymer; PCTFE; PCTFE film; PCTFE sheet; polychlorotrifluoroethylene; ICS Number Code 83.140.10 (Films and sheets)

To find similar documents by ASTM Volume:

08.02 (Plastics (II): D3222 - D5083)

To find similar documents by classification:

83.140.10 (Films and sheets Including plates)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ASTM-D3595-02(2007)

Revision Level

2002 R07 EDITION

Status

Superseded

Modification Type

Reapproval

Publication Date

Nov. 1, 2007

Document Type

Specification

Page Count

3 pages

Committee Number

D20.15