ASTM-D4672 › Standard Test Method for Polyurethane Raw Materials: Determination of Water Content of Polyols
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method measures the water content of polyols and many other organic compounds.
1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
Note 1: This test method is equivalent to ISO 14897.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Significance and Use
5.1 This test method is suitable for quality control, as a specification test, and for research. The water content of a polyol is important since isocyanates react with water.
Keywords
Karl Fischer; polyols; polyurethane; raw materials; water content;
To find similar documents by ASTM Volume:
08.02 (Plastics (II): D3222 - D5083)
To find similar documents by classification:
83.080.20 (Thermoplastic materials)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D4672-24
Revision Level
2024 EDITION
Status
Current
Modification Type
Revision
Publication Date
Feb. 27, 2024
Document Type
Test Method
Page Count
3 pages
Committee Number
D20.22