ASTM-D4688 › Historical Revision Information
Standard Test Method for Evaluating Structural Adhesives for Finger Jointing Lumber
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 These test methods cover the evaluation of adhesives for finger jointing lumber used in the manufacture of structural glued laminated timber. They include tests of the tensile strength of joints; dry with no treatment, wet after one vacuum-pressure soak treatment, and wet after cyclic boil-dry treatment.
1.2 The values stated in inch-pound units are to be regarded as the standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
billet; failure mode; finger joint; horizontal joint; structural joint; vertical joint; ICS Number Code 83.180 (Adhesives)
To find similar documents by ASTM Volume:
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D4688-99
Revision Level
1999 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
Oct. 10, 1999
Document Type
Test Method
Page Count
7 pages
Committee Number
D14.30