ASTM-D4832 › Historical Revision Information
Standard Test Method for Preparation and Testing of Controlled Low Strength Material (CLSM) Test Cylinders
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers procedures for the preparation, curing, transporting and testing of cylindrical test specimens of controlled low strength material (CLSM) for the determination of compressive strength.
1.2 This test method also may be used to prepare and test specimens of other mixtures of soil and cementitious materials, such as self-cementing fly ashes.
1.3 CLSM is also known as flowable fill, controlled density fill, soil-cement slurry, soil-cement grout, unshrinkable fill, K-Krete, and other similar names.
1.4 The values stated in SI units are to be regarded as the standard. The inch-pound equivalents are shown for information only.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. See Section 7.
Keywords
backfill; CLSM; compressive strength; construction control; mix design; quality control; soil stabilization
To find similar documents by ASTM Volume:
04.08 (Soil and Rock (I): D420 - D5876)
To find similar documents by classification:
91.100.10 (Cement. Gypsum. Lime. Mortar)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D4832-95e1
Revision Level
1995(E1) EDITION
Status
Superseded
Modification Type
Revision with Title Change
Publication Date
Jan. 1, 1997
Document Type
Test Method
Page Count
5 pages
Committee Number
D18.15