ASTM-D4841 › Historical Revision Information
Standard Practice for Estimation of Holding Time for Water Samples Containing Organic and Inorganic Constituents
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This practice covers the means of estimating the period of time during which a water sample can be stored after collection and preservation without significantly affecting the accuracy of analysis.
1.2 The maximum holding time is dependent upon the matrix used and the specific analyte of interest. Therefore, water samples from a specific source must be tested to determine the period of time that sample integrity is maintained by standard preservation practices.
1.3 In the event that it is not possible to analyze the sample immediately at the time of collection, this practice does not provide information regarding degradation of the constituent of interest or changes in the matrix that may occur from the time of sample collection to the time of the initial analysis.
1.4 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
degredation; estimation; holding time; storage limit; water
To find similar documents by ASTM Volume:
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D4841-88(1998)
Revision Level
1988 R98 EDITION
Status
Superseded
Modification Type
Reapproval
Publication Date
June 24, 1988
Document Type
Practice
Page Count
6 pages
Committee Number
D19.02