Document Center is acquired by Nimonik

Scope

1.1 These test methods (A and B) determine the viscosities of polyols in the range from 10 to 100 000 mPas(cP) at 25°C or at 50°C. Test Method A also applies to more viscous samples that are soluble in n-butyl acetate. Test Method B is simply a reference to a general procedure for kinematic viscosity, D 445. (See Note 1.)

1.2 The values stated in SI units are to be regarded as the standard. Other equivalent units are provided because of current common usage.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Note 1—There is no equivalent ISO standard for Test Method A although ISO 3219 is similar. Test Method B is equivalent to ISO 3104.

Significance and Use

These test methods are suitable for research or as quality control or specification tests.

Viscosity measures the resistance of a fluid to uniformly continuous flow without turbulence or other forces.

Keywords

Brookfield; Cannon-Fenske; polyols; polyurethane raw materials; viscosity; ICS Number Code 83.040.30 (Auxiliary materials and additives for plastics); 83.080.20 (Thermoplastic materials)

To find similar documents by ASTM Volume:

08.02 (Plastics (II): D3222 - D5083)

08.03 (Plastics (III): D5117 - latest; Reinforced Plastic Piping Systems and Chemical Equipment; Plastic Building Products)

To find similar documents by classification:

83.040.30 (Auxiliary materials and additives for plastics Including fillers, extenders, hardeners, pigments, plasticizers, etc.)

83.080.20 (Thermoplastic materials)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.