Document Center is acquired by Nimonik

Scope

1.1 This practice describes procedures for the collection of an increment, partial sample, or gross sample of material using mechanical augers. Reduction and division of the material by mechanical equipment at the auger is also covered. Further manual or mechanical reduction or division of the material elsewhere shall be performed in accordance with Method D 2013.

1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

auger sampling; barge sampling; railroad car sampling; split-spoon sampling; stock pile sampling; truck sampling; ICS Number Code 73.100.30 (Equipment for drilling and mine excavation)

To find similar documents by ASTM Volume:

05.06 (Gaseous Fuels; Coal and Coke)

To find similar documents by classification:

73.100.30 (Equipment for drilling and mine excavation Including equipment for seabed mining Drilling equipment for the petroleum industry, see 75.180.10)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.