ASTM-D5166 › Standard Practice for Laboratory Preparation of Gelled Vehicle Samples Using a Microwave Oven (Withdrawn 2022)
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This practice outlines a procedure for preparing gelled vehicle samples using a microwave oven.
1.2 The test samples can be used for characterizing the gelability or reactivity of resins, gelling agents, and vehicles used in the manufacture of oil based printing inks, or both.
1.3 Evaluation of the gelled vehicles may, depending upon preference, be either visual or instrumental.
1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Significance and Use
5.1 This practice provides a means of preparing a number of gel vehicle samples with minimum use of materials and time. It provides a means of quickly characterizing and comparing the gelability or reactivity of resins, vehicles, and gelling agents.
Keywords
gel; gelability; gelled varnish; gelled vehicle; microwave oven; non-Newtonian fluid; pregel; pregel varnish; pregel vehicle; shortness ratio; slope; yield value;
To find similar documents by ASTM Volume:
To find similar documents by classification:
71.040.40 (Chemical analysis Including analysis of gases and surface chemical analysis)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D5166-97(2016)
Revision Level
1997 R16 EDITION
Status
Cancelled
Modification Type
Withdrawn
Publication Date
April 1, 2016
Document Type
Practice
Page Count
4 pages
Committee Number
D01.37