ASTM-D5292 › Historical Revision Information
Standard Test Method for Aromatic Carbon Contents of Hydrocarbon Oils by High Resolution Nuclear Magnetic Resonance Spectroscopy
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers the determination of the aromatic hydrogen content (Procedures A and B) and aromatic carbon content (Procedure C) of hydrocarbon oils using high-resolution nuclear magnetic resonance (NMR) spectrometers. Applicable samples include kerosenes, gas oils, mineral oils, lubricating oils, coal liquids, and other distillates that are completely soluble in chloroform at ambient temperature. For pulse Fourier transform (FT) spectrometers, the detection limit is typically 0.1 mol % aromatic hydrogen atoms and 0.5 mol % aromatic carbon atoms. For continuous wave (CW) spectrometers, which are suitable for measuring aromatic hydrogen contents only, the detection limit is considerably higher and typically 0.5 mol % aromatic hydrogen atoms.
1.2 The reported units are mole percent aromatic hydrogen atoms and mole percent aromatic carbon atoms.
1.3 This test method is not applicable to samples containing more than 1 mass % olefinic or phenolic compounds.
1.4 This test method does not cover the determination of the percentage mass of aromatic compounds in oils since NMR signals from both saturated hydrocarbons and aliphatic substituents on aromatic ring compounds appear in the same chemical shift region. For the determination of mass or volume percent aromatics in hydrocarbon oils, chromatographic, or mass spectrometry methods can be used.
1.5 The values stated in SI units are to be regarded as the standard.
This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
aromatic carbon content; aromatic hydrogen content; continuous wave; Fourier transform; hydrocarbon oils; NMR; nuclear magnetic resonance spectroscopy; ICS Number Code 75.080 (Petroleum products in general)
To find similar documents by ASTM Volume:
05.02 (Petroleum Products and Lubricants (II): D3711 - D6122)
To find similar documents by classification:
75.080 (Petroleum products in general)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D5292-99(2004)
Revision Level
1999 R04 EDITION
Status
Superseded
Modification Type
Reapproval
Publication Date
Nov. 1, 2004
Document Type
Test Method
Page Count
7 pages
Committee Number
D02.04.0F