ASTM-D5505 Historical Revision Information
Standard Practice for Classifying Emulsified Recycling Agents

ASTM-D5505 - 2006 EDITION - SUPERSEDED
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:

Standard Practice for Classifying Emulsified Recycling Agents
ORDER

Scope

1.1 This practice identifies emulsified petroleum products that may be used as recycling agents in recycled mixes. These materials are classified by viscosity or by low temperature penetration after aging.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to consult and establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

1.2 This practice addresses emulsified materials designed specifically for use in recycling. The use of emulsified materials for recycling shall not be limited to this practice. For instance, the emulsions specified in Specifications D 977 and D 2397 may be used.

Significance and Use

Recycling of deteriorated asphalt pavements is being used as a routine method of maintenance and rehabilitation. Utilization of existing materials as the major component of this procedure may yield benefits in quality, economy, and preservation of natural resources. Recycling takes many forms; hot, cold, in-situ, central plant and surface. This practice may be used for various recycling methods.

Keywords

emulsified recycling agent; emulsions; recycling; ICS Number Code 75.080 (Petroleum products in general); 75.100 (Lubricants, industrial oils and related products)

To find similar documents by ASTM Volume:

04.03 (Road and Paving Materials; Vehicle-Pavement Systems)

To find similar documents by classification:

75.080 (Petroleum products in general)

75.100 (Lubricants, industrial oils and related products Including mineral oils, fluids for metal working and for temporary protection against corrosion Lubrication systems, see 21.260 Insulating oils, see 29.035.40)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ASTM-D5505-06

Revision Level

2006 EDITION

Status

Superseded

Modification Type

Revision

Publication Date

Dec. 1, 2006

Document Type

Practice

Page Count

2 pages

Committee Number

D04.41