ASTM-D5751 › Standard Specification for Adhesives Used for Laminate Joints in Nonstructural Lumber Products
The following bibliographic material is provided to assist you with your purchasing decision:
This specification covers performance levels for adhesives to be used in laminate joints in nonstructural lumber products. Such products include, but are not limited to, interior and exterior mouldings, window and door components or parts, and bonded lumber panels. This specification is to be used to evaluate adhesives as well as the adhesive bonds in nonstructural-glued-lumber products. Dry test, soak test, elevated temperature test, boil test, and vacuum pressure test shall be performed to meet the requirements prescribed. The precision and bias of exposure condition shall be tested to meet the requirements prescribed.
Scope
1.1 This specification covers performance levels for adhesives to be used in laminate joints in nonstructural lumber products. Such products include, but are not limited to, interior and exterior mouldings, window and door components or parts, and bonded lumber panels. This specification is to be used to evaluate adhesives as well as the adhesive bonds in nonstructural-glued-lumber products.
Note 1: This specification supersedes the laminate-joint portion of Specification D3110.
Note 2: See 3.2.1 and 3.2.2 for descriptions of a dry-use-nonstructural adhesive and a wet-use-nonstructural adhesive.
1.2 This specification applies to laminate-joint specimens made under both laboratory and field conditions. See Section 4 for limitations in using this specification to evaluate industrially manufactured laminate joint products.
1.3 The following safety caveat applies only to the apparatus and test methods portions, Sections 6, 7, 8, and 9 of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 The values stated in inch-pound units are to be regarded as standard.
1.5 In this specification, laminate joint refers to both face and edge joints.
1.6 The following index is provided as a guide to the test methods in this specification:
| Section |
Apparatus | 6 |
Conditioning | 7 |
Material and Preparation of Assemblies and Specimens | 8 |
Exposure Conditions and Treatments | 9 |
Testing, Calculation, and Reporting | 10 |
Note 3: The conditioning needed for various stages in the preparation of the specimens and for the exposure tests are given in Sections 7, 8, and 9.
1.7 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Keywords
bonded; dry-use-nonstructural adhesive; edge joint; face joint; laminate joint; nonstructural lumber; wet-use adhesive;; ICS Number Code 83.180 (Adhesives)
To find similar documents by ASTM Volume:
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D5751-99(2019)
Revision Level
1999 R19 EDITION
Status
Current
Modification Type
Reapproval
Publication Date
Feb. 1, 2019
Document Type
Specification
Page Count
11 pages
Committee Number
D14.30