ASTM-D5976 › Standard Specification for Type I Polymer Modified Asphalt Cement for Use in Pavement Construction (Withdrawn 2005)
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This specification covers asphalt cements that have been modified by the addition of an appropriate polymer for use in pavement construction. It was developed to provide a reference for specifying polymer-modified asphalt and reflects the properties of currently available commercial products. This is not intended to be a performance-based specification.
1.2 Type I polymer-modified asphalts are typically made with styrene-butadiene-styrene block copolymers. However, any polymer may be used that will give the required test results when blended with the desired asphalt.
1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
asphalt; polymer modified asphalt; specification; ICS Number Code 93.080.20 (Road construction materials)
To find similar documents by ASTM Volume:
04.03 (Road and Paving Materials; Vehicle-Pavement Systems)
To find similar documents by classification:
93.080.20 (Road construction materials Including asphalts, road pavements, etc.)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D5976-00
Revision Level
2000 EDITION
Status
Cancelled
Modification Type
Withdrawn
Publication Date
Dec. 10, 2000
Document Type
Specification
Page Count
2 pages
Committee Number
D04.45