Document Center is acquired by Nimonik

1.1 This test method covers the determination of impact resistance of new low slope roof membranes when applied directly over rigid insulation or cover board, or structural concrete, lightweight insulating concrete, gypsum, cementitious wood fiber or wood roof decks. The procedures were developed to determine the potential for puncture or fracture of the new roof membrane resulting from impacts by free falling steel balls resulting in specific impact energies when the new roof membrane is applied over its tested substrate within an assembly.

1.2 This test method is intended to verify that products as described will meet a specific stated condition of impact resistance performance. Testing of asphalt shingles is beyond the scope of this test method. The tests yield classification identified as Class 2 and Class 3.

1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

6.1 This test method provides a means of evaluating new roof membranes for resistance to specific impact energies. The method evaluates new roof membranes when first applied and also after simulated deterioration caused by the ultraviolet radiation and moisture.

6.2 Use Class 2 for an impact resistance of 11.0 ± 0.3 J [8.1 ± 0.2 ft-lb] and Class 3 for an impact resistance of 19.4 ± 0.4 J [14.3 ± 0.3 ft-lb].